Electronics Forum | Fri Jul 26 12:41:25 EDT 2013 | gallionc
We've had similar "disputes" with our quality department. A technical engineer from Nordson told me that the flourescents in the coating can look faint depending on the angle in which you look at the surface as well as how solder joints reflect the
Electronics Forum | Sat Oct 15 01:47:09 EDT 2022 | auriga2001
I might need some help to explain what I'm seeing here. The first 3 look like before pictures. They seem ok. The last 3 look like after pictures. It doesn't look like fracturing joints as would be a normal failure for vibration test, more like it rea
Electronics Forum | Sat Dec 03 16:26:40 EST 2005 | grantp
Hi, I have seen demos of these scopes, and don't think they really show you very much. If you profile your board right, and drill up to solder a thermocouple onto the inner balls of the device so you really know your getting a good profile, I don't
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Thu Jan 19 13:28:19 EST 2012 | waveroom
Two pictures. Dark circles around solder joints. leaded solder, water soluble flux, selective soldering and seeing these dark lines circling around solder joints. Can not remove this either. Any idea what is making this occur??? See attached photos
Electronics Forum | Tue Nov 13 12:25:12 EST 2007 | gradloff
I have a thick board with ground planes that will be soldered by hand with a mildly active solder/flux. X-ray confirmed that solder was added to the top of the joint causing a void between the bottom and top solder joint. Other than the mildly acti
Electronics Forum | Sun Oct 19 05:58:08 EDT 2008 | bejingaf
Hello! I'd like to now if you have similar requests from your customers as we have that we are not alloved to manually repair solder joints after reflow or wave soldering process? Regards!
Electronics Forum | Thu Oct 26 03:20:13 EDT 2000 | heccles
What would be a typical thermal test regime to verify the quality of solder joints for high specification applications - what would be the specific benefits of utilizing a "HALT" process over other traditional test techniques ?
Electronics Forum | Wed Nov 14 10:51:34 EST 2007 | mumtaz
Yes. Baking boards is best. Hitting the hamer on the head!
Electronics Forum | Tue Oct 21 10:25:05 EDT 2008 | hussman
They must live in a perfect world where they give you perfect boards and perfects parts.
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936
